PoolBelt – Fastening set for tarpaulins

To allow rainwater, snow, etc., to drain away, it is necessary to secure the tarp tightly, pulling it downward. To that end, we have fastening set for several common basin sizes that meets this requirement.

The problem

First, here’s an example of what not to do. The pool cover is the perfect size for the pool shown. The cover was placed over the pool and secured all around with a rubber band. However, as soon as it rains, a pool of water forms around the pool. Why? The cover slides upward and sags under the weight of the water. That’s what we need to prevent!

PoolBelt the solution

The tarp must be secured by pulling it downward so that it cannot slide upward. Together with our customers, we have developed a belt system for steel frame pools which ensures that the pool is tensioned tightly at the bottom. We’ll walk you through the process of putting on the PoolBelt step by step.

Threading the loops: Thread the loops provided into the long, wide strap. They’ll help you attach the short ribbons later.

Attaching the horizontal ribbon: Now wrap the long, wide ribbon around the pool. The filled steel-frame pool forms a curve, which we take advantage of. So you attach the horizontal strap between the pool liner and the steel frame. Now fasten the buckle strap. In the size chart, you’ll find the length of the horizontal webbing included in our sets. If your pool is larger, you can simply use the extension strap and connect it to the horizontal strap of the PoolBelt set.

Distribute the loops evenly around the pool and place one of the vertical straps at each loop. Once everything is set up and the pool cover is on the pool, you can start stretching it out. To do this, thread the vertical clamp strap through the loop and the grommet on your pool cover. Start by tightening the strap only slightly, and repeat this step for all the vertical straps.

Only after all the straps are attached to the cover should you gradually tighten them. Only a tightly stretched tarp will help you avoid puddles.

If your tarp doesn’t have grommets, you can simply use our slide clips. The clips are already included with the PoolBelt sets. They’re also very useful if, for example, your filter system is in the way and you can’t properly secure the cover there. Just use the sliding clips here to stay flexible.

The bracing for steel wall pools

In steel-frame pools, the horizontal web is located beneath the “curvature” or “bulge” of the pool. This automatically secures it in place so it can’t slip. With steel-walled pools, it is not possible to secure the strap underneath the pool, and the strap would slide up the smooth surface. We therefore recommend our system only for steel-frame pools.

For built-in pools or steel wall pools, it is best to use ground anchors around the pool to which the tarpaulin is attached with (non-stretchable) ropes.

Tip: You can use our Midi Clips and textile ropes, for example.

Leave a Reply

Your email address will not be published. Required fields are marked *

Black Week Angebote - Jetzt bis zu 22% Rabatt sichern!

21.11. – 30.11.2026 | Nur solange der Vorrat reicht!